NITROGEN REMOVAL

aeration and HOMOGENIZATION

TO INCREASE THE EFFICIENCY OF

NITRIFICATION AND DENITRIFICATION


Mild gaseous supercavitation for aeration and powerful steam cavitation for homogenization allows WWTPs to achieve the highest quality

of nitrogen removal at the lowest cost.


  • Oxygen for nitrification
    CAVITECH Aeration allows you to increase your sludge dose and dissolved oxygen concentration.
  • Easily oxidized organic substrate for denitrification
    The CAVITECH homogenizer creates a source of easily oxidized organic matter for denitrification from excess activated sludge.

oxygen for nitrification

CAVITECH AERATION MODULE

main or additional aeration
Very often a low nitrification is caused by a lack of oxygen in the aeration tank. The existing system may not be able to cope with the dose of ammonium entering the aeration tank.
In this case, CAVITECH is an excellent solution as additional aeration equipment.
The CAVITECH module can be installed over an existing system without stopping the structure. We place the module directly into the water bubbling during the cleaning process.
There is no need to stop and drain.

HOMOGENIZATION

valuable source from by-product

How We Do It


CAVITATION HOMOGENIZER

Homogenization based on steam cavitation leads to the formation of a nutrient substrate from homogenized sludge with a high content of easily oxidized organic matter. This substrate stimulates the decomposition of nitrates to molecular nitrogen under the action of denitrifying bacteria.

MAIN CONDITION FOR DENITRIFICATION
Denitrification is ineffective due to the low content of easily oxidized organic matter in the wastewater. Especially if the denitrification zone is located after the nitrification zone, and most of the organic matter has already been absorbed. Then it makes sense to homogenize excess sludge, which is a by-product and is discharged outside the structure.
GROWTH OF COD MORE THAN 5 TIMES

Testing the efficiency of homogenization of excess sludge showed an increase in dissolved COD from 251 mg/l to 1319 mg/l

Advantages

FOR YOU, FOR PURE WATER,

FOR the PLANET.

LET'S MAKE a DIFFERENCE


  • INTENSIFICATION OF THE PROCESS
    Increasing the energy efficiency of aeration with CAVITECH means an increase in oxygen concentration for the same energy input.
    This gives you the following advantages:
    1) a guarantee of removal of ammonia nitrogen

    2) the ability to increase the dose of activated sludge

  • 4-6 g/l is enough for intensification

    In such cases, we advise aiming for a free suspended sludge dose of 4-6 g/l.

    This intensifies the process, but does not lead to the removal of activated sludge from the secondary settling tank

  • Use throwaway

    Our homogenization solution allows you to turn into a valuable source what you are used to recycling - excess sludge.

  • New result in the same footprint

    intensification of processes due to additional oxygen during nitrification and cheap organic matter during denitrification allows you to achieve a higher quality of purification in the same size of the facility.

  • Improve quality without stopping the process

    Modernization of the aeration system due to the installation of CAVITECH can take place without stopping the operation of the structure.

  • Flexibly change zones of nitrification and denitrification
    CAVITECH aeration module can flexibly change its oxygen dissolution performance from oxic to anoxic. This allows you to change the nitrification and denitrification zones.
  • See how CAVITECH can improve your process
  • Learn about 3 simple steps to your new effective aeration system
  • Do you want to get free the design of the aeration system? Our experienced experts are at your service. Send us free request or download Question sheet

HOW TO BUY

A FEW COMMON STEPS TO A GOOD DEAL.

HOW we work

  • STEP 1 - YOUR REQUEST
    Since you decide to try CAVITECH, you may send us your request via email
    kk@cavitech.org
  • STEP 2. A SHORT QUESTION SHEET
    Since we'll get your request, we shall send you additional information and our question sheet to give you an offer tailored to the specifics of your facility.
  • STEP 3. DISCUSSION AND APPROVAL OF THE PROPOSAL
    It will take us no more than a week to send you our technical and commercial proposal. Next, we will discuss it in detail and, if necessary, hold an on-site meeting to obtain a solution agreed upon by both parties.

VIDEO

BETTER TO SEE ONCE.

To get an idea of how CAVITECH can work in your facility, watch our videos of real-life implementation projects. This will help you further discuss and agree on our proposals for you.


https://www.youtube.com/@CavitechAeration

Contact

GET IN TOUCH.

Request your design of an energy-saving aeration
Email kk@cavitech.org for your request
or
send us your email for additional information
Thank you so much!
© 2023 CAVITECH
All rights reserved
CAVITECH GROUP


CAVITECH Limited (Israel)
CAVITECH INNOVATION (Serbia)
Phone
+97 252 2536251
+381 62 9359023
Email
kk@cavitech.org

Made on
Tilda